DComTalk.com

Walter Roberson · Guest

Would anyone happen to have a program to dump out saved [binary]
configurations from Baystack 450-24T's ?

A 450 stack will only load in a previously saved configuration if the
configuration was saved with exactly the same number of units in the
stack. If one happens to have changed the number [e.g., problem with
the cascade modules...] then it would be useful to be able to go back
and dump the saved configuration rather than having to write down all
the VLAN information before the work. {When you put a stack back
together, the VLAN information of the individual units often gets wiped
out :( }

Even nicer would be an 450 binary configuration editor, but that's
perhaps expecting a bit too much.

[Would anyone happen to know how they do the CRC calculation?]

The file format seems to be a bit of a dogs breakfast :(
--
Look out, there are llamas!

Chuck R. Anderson · Guest

Walter Roberson <roberson@ibd.nrc-cnrc.gc.ca> wrote:

Walter Roberson · Guest

In article <slrnd8016k.5uc.craIHateSpam@angus.ind.WPI.EDU>,
Chuck R. Anderson <craIHateSpam@wpi.edu> wrote:
:Walter Roberson <roberson@ibd.nrc-cnrc.gc.ca> wrote:
:> Would anyone happen to have a program to dump out saved [binary]
:> configurations from Baystack 450-24T's ?

:Newer BayStacks have an Ascii Config Generator which will dump all the
:NNCLI commands needed to recreate the config on the switch. Does the
:450 have such a thing?

Unfortunately No :(

The next iteration, the 470 -can- generate an Ascii config, but it
can't read one in (at least not in any obvious way). And the 470
won't read a 450 config, I'm pretty sure.
--
Studies show that the average reader ignores 106% of all statistics
they see in .signatures.

Guest · Posted: Wed May 11, 2005 4:21 pm Post subject: Re: baystack 450 config parser?

Walter Roberson wrote:

Walter Roberson · Guest

In article <1115818727.227197.289690@g14g2000cwa.googlegroups.com>,
<rick.harris@scdmv.net> wrote:
|Walter Roberson wrote:

|> :> Would anyone happen to have a program to dump out saved [binary]
|> :> configurations from Baystack 450-24T's ?

|There was a product called NCS(no longer supported,but available on
|Nortel's website). You could download the config(s),then edit them.

I had a look and found the right page. Unfortunately it hasn't
been released as free (and isn't purchasable.)

When I was investigating NCS, I found something in there that reminded
me that the information that is needed for my purposes is accessible
via SNMP, so I will write some SNMP queries to extract the information
live.
--
Entropy is the logarithm of probability -- Boltzmann

	DComTalk.com Forum Index -> Bay Networks	All times are GMT
Page 1 of 1