DComTalk.com

Hi !!
I have been praticing the configuration of this ethernet switch for a
while and it kicked me off while I was making some VLAN
configuration..well right now I can't access to the switch..I can't
ping or anything..I reset it and tried to set the IP address to the
default (192.168.192.168) by using the user button on the front
panel..unfortunately nothing worked....what could be the reason....does
anyone have an idea...I am kinda desperate :)
Could there be a problem with my networking setting..actually I give
static IP to my laptop when I try to connect to the switch
(192.168.192.169) but after that VLAN config it started not to work at
all...I dont understand why it still doesnt gimme any access even after
reset ???

Thanks for any help....

eksantrik wrote:

Hi !!
I have been praticing the configuration of this ethernet switch for a
while and it kicked me off while I was making some VLAN
configuration..well right now I can't access to the switch..I can't
ping or anything..I reset it and tried to set the IP address to the
default (192.168.192.168) by using the user button on the front
panel..unfortunately nothing worked....what could be the reason....does
anyone have an idea...I am kinda desperate :)
Could there be a problem with my networking setting..actually I give
static IP to my laptop when I try to connect to the switch
(192.168.192.169) but after that VLAN config it started not to work at
all...I dont understand why it still doesnt gimme any access even after
reset ???

Thanks for any help....

Dude, I did the same thing while setting up the 5520. For me the error
was this: The switch management is setup by default on VLAN 0 or 1.
When I setup my VLan I assign all the ports to the new VLAN and I was
upable to access the management IP address. You have to go in and
change the management to the new VLAN id and this should solve your
problem. Hope that helps.

but I reset it and set the default IP again..It doesnt make any sense,
does it?
I can't even ping the switch anymore...