| Author |
Message |
Greg
Guest
|
 Posted:
Tue Dec 21, 2004 10:01 pm Post subject:
downstream power level? |
|
|
What is the typical downstream power level for a cable modem?
My modem seems OK although I don't really know what the performance is. My TV
channels 2-6 suck. I know this is the same band. My modem says 3dB. Is that
low? Can it tolerate a bump up to improve the TV signal? |
|
| Back to top |
|
 |
BigJIm
Guest
|
| Posted:
Tue Dec 21, 2004 10:37 pm Post subject:
Re: downstream power level? |
|
|
some of my channels suck that is why I have satellite with the local
channels.
I also have broadband, wish I could get dsl and completely rid myself of
Comcast.
as far as your problem it is probably a line issue, bad connector or
something.
"Greg" <gfretwell@aol.com> wrote in message
news:20041221120138.06135.00001694@mb-m23.aol.com...
| Quote: | What is the typical downstream power level for a cable modem?
My modem seems OK although I don't really know what the performance is. My
TV
channels 2-6 suck. I know this is the same band. My modem says 3dB. Is
that
low? Can it tolerate a bump up to improve the TV signal? |
|
|
| Back to top |
|
|
Bit Twister
Guest
|
| Posted:
Tue Dec 21, 2004 11:53 pm Post subject:
Re: downstream power level? |
|
|
On 21 Dec 2004 17:01:38 GMT, Greg wrote:
| Quote: | What is the typical downstream power level for a cable modem?
My modem seems OK although I don't really know what the performance is. My TV
channels 2-6 suck.
|
Have see people with good tv signal and poor internet cable values.
Internet drop outs/failures users also had poot tv.
If no problems with internet, then I would check tv path.
| Quote: | I know this is the same band. My modem says 3dB. Is that low?
|
Hmmm, mine i -1dbv.
| Quote: | Can it tolerate a bump up to improve the TV signal?
|
Look up the specs on your cable modem.
I would not recommend you placing an amp in front of your cable modem. |
|
| Back to top |
|
|
Andrew Rossmann
Guest
|
| Posted:
Wed Dec 22, 2004 2:30 am Post subject:
Re: downstream power level? |
|
|
[This followup was posted to comp.dcom.modems.cable and a copy was sent
to the cited author.]
In article <20041221120138.06135.00001694@mb-m23.aol.com>,
gfretwell@aol.com says...
| Quote: | What is the typical downstream power level for a cable modem?
My modem seems OK although I don't really know what the performance is. My TV
channels 2-6 suck. I know this is the same band. My modem says 3dB. Is that
low? Can it tolerate a bump up to improve the TV signal?
|
Does your cable modem list the downstream and upstream frequencies?
Most commonly, downstream will be very high, like in the 600-700's. That
is well into the UHF channels (or cable channels 85+). Channels 2-6 are
roughly 50-88MHz. Upstream usually uses frequences below 50.
+3db is good. The recommendation is +15 to -15, although some
recommend trying to keep it +8 to -8. You also need to check SNR (Signal
to Noise Ratio). It should be 30+. Upstream should be below 55db.
http://www.speedguide.net/read_articles.php?id=1197
Noise and problems with channels 2-6 often mean a poor cable ground
someplace. Double-check all your connections. Also, verify that any
splitters are rated 5-900 or 5-1000. Replace any that are unrated, or
start at 40 or 50MHz.
--
If there is a no_junk in my address, please REMOVE it before replying!
All junk mail senders will be prosecuted to the fullest extent of the
law!!
http://home.att.net/~andyross |
|
| Back to top |
|
|
Greg
Guest
|
| Posted:
Wed Dec 22, 2004 3:22 am Post subject:
Re: downstream power level? |
|
|
Thanks Andy, I am in the process of swapping out all of the cable on my side
with brand new quad shield. I have a "real" crimper and I am using good
connectors. We will see.
So far I have found some questionable stuff so I do have some confidence I am
fixing something |
|
| Back to top |
|
|
|
|
|
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in