| Author |
Message |
Big Rich
Guest
|
 Posted:
Sat Oct 29, 2005 8:21 am Post subject:
MICS 7.0 and PRI problem |
|
|
Need some help installing a full PRI into a new MICS with DID targets and
incoming and outbound calling. Bought the PRI enabler, entered the keycodes
and seemed to take. But cannot see the PRI. Card keeps blinking green. We
are pretty sure the settings for ESF, Wink, Digit length etc are correct but
must be overlooking something. Any ideas?
Thanks |
|
| Back to top |
|
 |
John
Guest
|
| Posted:
Sat Oct 29, 2005 4:20 pm Post subject:
Re: MICS 7.0 and PRI problem |
|
|
Are you sure the Pri is up? Did you change the trunk type from COT to DID
or whatever for the 23 B channels. Or the card type in maint.
John 807
"Big Rich" <remark@comcast.net> wrote in message
news:gaudndMmbJpahv7eRVn-vQ@comcast.com...
| Quote: | Need some help installing a full PRI into a new MICS with DID targets and
incoming and outbound calling. Bought the PRI enabler, entered the
keycodes and seemed to take. But cannot see the PRI. Card keeps blinking
green. We are pretty sure the settings for ESF, Wink, Digit length etc are
correct but must be overlooking something. Any ideas?
Thanks
|
|
|
| Back to top |
|
|
Guest
|
| Posted:
Sun Oct 30, 2005 4:15 am Post subject:
Re: MICS 7.0 and PRI problem |
|
|
Although your telco may tell you the PRI is up, there could still be
some issues between the CO and your site. If you're sure your settings
are good, call the Telco and have them do a loopback test both through
your equipment and to their demarc |
|
| Back to top |
|
|
|
|
|
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in