Clear TN info from a i2004
DComTalk.com Forum Index DComTalk.com
Discussion of VoIP, VPN, Video Conferencen, DSL and other data commucations.
 
 FAQFAQ   MemberlistMemberlist     RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 
Google
 
Web dcomtalk.com
Clear TN info from a i2004

 
Post new topic   Reply to topic    DComTalk.com Forum Index -> Nortel
Author Message
Jeff Pratt
Guest
Posted: Thu Aug 25, 2005 12:21 am    Post subject: Clear TN info from a i2004 Reply with quote
Hello;

We've been provided with an i2004 that was previously in another location.
They are using another superloop (60) to carry their set programming for IP
sets. How do I clear the existing TN in order to put in a correct TN? The
listed procedure only works if the set registers and has a valid TN.
Otherwise you get the Unequipped screen, with only a reset key.

Jeff
Back to top
compufxr
Guest
Posted: Thu Aug 25, 2005 4:21 pm    Post subject: Re: Clear TN info from a i2004 Reply with quote
You need to reset the phone. When the Nortel logo comes up -
immediately run your finger along all 4 buttons directly below the
screen. This will put you into setup mode. You can then change the
settings for the phone - DHCP, ip address, port numbers, etc.

When the phone connects to the system and displays the TN and Node
numbers - immediately press the backspace or delete key on the phone
and you can then enter a new TN and Node.

Hope this helps!
Back to top
Jeff Pratt
Guest
Posted: Fri Aug 26, 2005 12:21 am    Post subject: Re: Clear TN info from a i2004 Reply with quote
Whoops, mailed reply instead of posting. Sorry compufxr.

compufxr wrote:

Quote:
You need to reset the phone. When the Nortel logo comes up -
immediately run your finger along all 4 buttons directly below the
screen. This will put you into setup mode. You can then change the
settings for the phone - DHCP, ip address, port numbers, etc.

When the phone connects to the system and displays the TN and Node
numbers - immediately press the backspace or delete key on the phone
and you can then enter a new TN and Node.

Hope this helps!

Thanks.  I've already set the IP, port numbers, etc. to match our system. 
The problem I'm having is that the screen showing node and TN never appears
if the phone already has a TN configured that is not valid for the switch
that it's currently on.  

The TN that's currently programmed into the phone: 60-4
The TN I'd like to program into the phone: 61-6

Rather than seeing the TN and node screen, I get a screen showing: "Invalid
TN 60-4 Reason: Unequipped".  This screen only has a reset key
that reboots the phone.  

To see this, simply out the TN that an i2004 is on, and reboot the phone.
I'd have to find the original system this phone was on, hook the phone up
there, and reprogram the TN there to use the standard procedure.

Thanks, though.

Jeff
Back to top
 
Post new topic   Reply to topic    DComTalk.com Forum Index -> Nortel All times are GMT
Page 1 of 1

 
 You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum




VoIP Solutions: Telephone Systems Electronics Satellite TV Tech & Gadgets
Powered by phpBB