Beer Guy
Guest
|
 Posted:
Thu Aug 18, 2005 12:20 am Post subject:
Trouble with Netgear FVS114 establishing VPN |
|
|
I have three Netgear FVS114 FW v1.0 VPN Firewall Routers that I have
set up at different locations with an Aggressive - Both Directions
"gateway-to-gateway" IPSEC VPN connection between them. I am using
fully qualified domain names as IDs for the three gateways.
There are two issues I am experiencing:
1. When any of the FVS114s are configured with an IKE and VPN policy
they will run for 30 minutes to an hour (with the tunnel functioning),
at which point they will lock up so that they will not respond to pings
from the LAN or the WAN side, will not pass data on the LAN or to the
WAN, and cannot be logged into via the administration page.
2. While the VPN tunnel functions on initial configuration of the
policies, when the FVS114 is rebooted (either by soft reboot from the
administration page or by pulling the power cord after the FVS114 has
locked up) the VPN tunnel is not reestablished. If I try to edit the
IKE policy after a restart I get an error message: "ERROR: no matching
policy found".
These two problems occur on all three FVS114s.
I realize this might not be the best group to post this question but I
am getting little help from the Netgear forum and no help as of today
from Netgear Support. |
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in