DComTalk.com

troydavidsmith · Guest

I moved into a small apartment with Cat 5 run throughout and want to run
phone and ethernet over these lines. I have spent some time trying to get
this to work but haven't had much luck. Wondering if anyone has any
advice?

The set up is:

I have two phone lines; one for upstairs and one for my office in the
garage. The garage line carries the DSL service.

From the MPO I have two wires that go into a small phone jack.
I have attached my DSL splitter to this jack.
DSL splitter has phone out and DSL out.
DSL out runs to a 4 outlet router.
Phone runs to a 3-way splitter (I may run this to a punch down block....)

Using the Cat5, I have pulled the blue and white wires away from the rest
allowing about 6 inches of wire and put an RJ11 jack onto it. I plug this
into the splitter. The other end is already connected to the phone jack
and works great.

I have then pulled the Orange and Green pair (still twisted) and cut them
about 1 inch from the jacket. I then put them into an RJ45 jack into
1,2,3 and 6. (OW/O/GW/G) This I plugged into the router and the other
end into my computer. This DID NOT WORK.

Help??

Thanks!!!

-------------------------------------

##-----------------------------------------------##
Article posted with Cabling-Design.com Newsgroup Archive
http://www.cabling-design.com/forums
no-spam read and post WWW interface to your favorite newsgroup -
comp.dcom.cabling - 938 messages and counting!
##-----------------------------------------------##

Robert Redelmeier · Guest

troydavidsmith <troydavidsmith_at_hotmail_dot_com@foo.com> wrote:

	DComTalk.com Forum Index -> Cabling	All times are GMT
Page 1 of 1